Factory-trained installers can complete the job in less than a day.
A tub can usually be installed in 2-4 hours. With a new wall surround, ceiling panel, new faucet or other accessories, a new bath system can still typically be installed in the same day. You can use the bath the next morning.

Our acrylic liners and wall systems are installed directly over your old tub and walls so no demolition is necessary*. (only if the existing walls are solid and don’t have any damage)

With proper care, the durable acrylic finish will keep its lustrous beauty indefinitely. And it won’t chip, crack, peel or dent. Plus, Deluxe Bath offers a lifetime manufacture’s warranty.

Deluxe Bath systems eliminates the need for grouting, as well as other tile maintenance problems.

We have molds for 4.5’, 5’, and 5.5’ steel and cast-iron tubs. A dent, rust or refinishing that is pulling away is no problem. If the existing fiberglass tub provides sufficient structural strength, a tub liner can be installed in quite a few styles.

YES. In fact, a lot of homeowners with two bathrooms are going that now, and the home retains or exceeds its original resale value. We can also line very small showers or very large showers.

NO. We use three separate pieces for a few reasons:

NO. We put a primer on the walls before they’re installed. Afterwards, the seal is to tight that air no longer circulates which is a necessary requirement for mold or mildew to grow.

We do windows! And ceilings and wainscoting and cap knee walls – So we are ready to personalize your bathroom.

It is not part of the standard install. We do offer it, however. We/Our plumber are able to change a two-handle valve to a single lever, as well. We only put in valves meeting plumbing codes which requires pressure-balanced and temperature balanced faucets which means you no longer get scalded when the dishwasher is turned on. We do replace your drain and overflow, though, in the tub. Because we’re installing ¼” material, we have to use a custom-made drain for the deeper length.

Acrylic is low maintenance and easy to clean with no scrubbing or harsh chemicals. Make a 50/50 solution of vinegar and water or 10/90 solution of bleach and water. Mix it in a spray bottle, spray on and rinse off with a soft cloth. Don’t use ammonia or aerosol cleanser, the propellant will cause cracks and void the warranty. Also, don’t use Tilex for the same reason. Usually, less is best – just wipe off areas where soap or shampoo accumulated.

Every system is covered by the manufacture’s limited lifetime warranty to be free of defects or flaws.